HPS Fusion™ FS1000KHP Non Stock
printPrint
  1. pin-int

HPS Fusion™ FS1000KHP

HPS Fusion™ FS1000KHP Dry Enclosed Control Transformer, 347/380 VAC Primary, 120/240 VAC Secondary, 1000 VA Power Rating, 50/60 Hz, 1 ph Phase

  • MPN: FS1000KHP
  • UPC: 803423107819
  • Min. Order Qty: 1
  • Quantity Interval: 1
  • loading loading
HPS Fusion™ FS1000KHP

The HPS Fusion™ line of enclosed transformers are an indoor, cost effective approach ideally suited for single phase, general purpose industrial and light duty loads. Designed specifically for applications such as general purpose enclosed applications used to adjust a supply voltage to match a load requirement, supplying motor control circuits, signal and alarm systems, industrial lighting and circuit isolation and HVAC applications. The HPS Fusion™ general purpose transformer is enclosed in a type 1 enclosure allowing for easy mounting and installation via four mounting slots and two keyhole slots. Easy access to primary and secondary wiring compartment through removable covers, which are molded terminal blocks on units up to 3000 VA and coil face terminations on units over 3000 VA.

HPS Fusion™ Control Transformer, Dry Enclosed, 347/380 VAC Primary, 120/240 VAC Secondary, 1000 VA, 50/60 Hz, 1 ph, 8.33/4.17 A Maximum, Terminal Block, Panel Mount, 130 deg C Class B, NEMA 1, 40 deg C, 5.6 in L x 8 in W x 5.1 in H

Connection Type      :      Terminal Block
Dimensions      :      5.6 in L x 8 in W x 5.1 in H
Enclosure Type      :      NEMA 1
Insulation      :      130 deg C Class B
Maximum Amperage Rating      :      8.33/4.17 A
Mounting Type      :      Panel
Temperature Rating      :      40 deg C
Type      :      Dry Enclosed
Primary Voltage      :      347/380 VAC
Secondary Voltage      :      120/240 VAC
Power Rating      :      1000 VA
Frequency Rating      :      50/60 Hz
Phase      :      1 ph
  • An indoor enclosed control transformer for easy surface mounting
  • Molded terminal blocks for primary and secondary connections
  • Coil face terminations over 3000 VA or 30 A
  • All terminal blocks utilize a combination slot/Phillips #6 screw with a SEMS washer
  • Coil face terminations utilize a 1/4-20 UNC x 0.5 in screw and a spring lock washer
  • 10 standard voltage groups
  • Rugged type 1 enclosure
  • Primary and secondary ground screws
  • Four wiring and accessory knockouts
  • FS-N1 enclosure